2 Solid LEDs when flashing eMMC on BeagleBone Black [Video]

I just picked up a beaglebone A6 a few days ago & I think I bricked it? I’ve been messing with arduino for years.
Right out of the box all the files on the eMMC were Zero KB so basically it had no drivers or start.htm
When I try to flash a new Angstrom image it processes but then stops on two solid LEDs.
Is there a way to get this fixed?

I’m using a 5V 2A power supply so I don’t think power is the problem.

Here is the video of what is going on
https://www.youtube.com/watch?v=yq-a1oJWGOw

Thank you!!

Pull power if you actually want to boot from the microSD card.
Hitting the reset button doesn't reset the boot select gpio pins..

Regards,