Angstrom next-eglibc u-boot problem

Hi everyone,

yesterday, I built basic image for beagleboard with narcissus based on
next-eglibc with u-boot. After copying MLO and u-boot.bin from image's
/boot, the kernel won't start. Neither .37 nor .32 kernel from image
will not boot. It didn't even shown "Starting kernel".

The same is reproducible with openembedded trunk build for
angstrom-2010.x beagleboard configuration.

After I replaced u-boot.bin with one supplied on the demo card, both
kernels started. I needed to change console parameter in boot.scr and
inittab to ttyO2 for the .37 kernel, but otherwise it works just fine.

Hope this information helps someone.

Regards,
Maksym Parkachov.
blog: http://veter-project.blogspot.com/