Loading u-boot.bin from mmc
U-Boot 2009.01-dirty (Feb 19 2009 - 12:23:21)
I2C: ready
OMAP3530-GP rev 2, CPU-OPP2 L3-165MHz
OMAP3 Beagle board + LPDDR/NAND
DRAM: 256 MB
NAND: 256 MiB
Using default environment
MUSB: using high speed
In: serial usbtty
Out: serial usbtty
Err: serial usbtty
Board revision C
Serial #6b22000300000000040323090d00a00a
Hit any key to stop autoboot: 0
reading boot.scr
** Unable to read "boot.scr" from mmc 0:1 **
reading uImage.bin
3009068 bytes read
reading ramdisk.gz
** Unable to read "ramdisk.gz" from mmc 0:1 **
Booting from mmc ...
## Booting kernel from Legacy Image at 80200000 ...
Image Name: Linux-2.6.33-rc4-git1-omap
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3009004 Bytes = 2.9 MB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Error, the USB hardware is not on B mode
Same error with USB on OTG or EHCI port.
Regards
Sid.