DevKit8000: Are there any jumper pins to erase the NAND Flash? How do I erase the NAND flash if I can't get to the boot command line?

DevKit8000: Are there any jumper pins to erase the NAND Flash? How do
I erase the NAND flash if I can't get to the boot command line?
Here is the message I get below. I cannot, get to the command line
because the board doesn't respond to me hitting any key on my
keyboard. Is there a way to hard erase the flash?

U-Boot 1.3.3 (Apr 22 2009 - 14:54:34)

OMAP3530-GP rev 2, CPU-OPP2 L3-165MHz
OMAP3 DevKit9000 Board + LPDDR/NAND
DRAM: 128 MB
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
reading uImage

** Unable to read "uImage" from mmc 0:1 **
Wrong Image Format for bootm command
ERROR: can't get kernel image!
OMAP3 DevKit9000 #

Hi,

Check ur minicom settings or the serial cable, u should be able to type in the u-boot prompt.

Harish,

I switched from putty to windows hyperterm, and that enabled access to
the u-boot prompt. not sure why that worked.

Thanks and Regards,

Will W

Harish,

I switched from putty to windows hyperterm, and that enabled access to
the u-boot prompt. not sure why that worked.

Thanks and Regards,

Will W

Hi,

K, now u can erase the flash using nand erase commands