Hi
I am running Beaglebone with Angstrom prebuild image and have a
following terminal output:
Importing environment from mmc ...
reading uImage
3042328 bytes read
## Booting kernel from Legacy Image at 80007fc0 ...
Image Name: Angstrom/3.1/beaglebone
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3042264 Bytes = 2.9 MiB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
XIP Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
[ 0.067600] omap_l3_smx omap_l3_smx.0: couldn't find resource
[ 0.195574] _omap_mux_get_by_name: Could not find signal leds-gpio
[ 0.579050] omap2_set_init_voltage: unable to get clk dpll1_ck
[ 0.585150] omap2_set_init_voltage: unable to set vdd_mpu_iva
[ 0.591235] omap2_set_init_voltage: unable to get clk l3_ick
[ 0.597173] omap2_set_init_voltage: unable to set vdd_core
The board freezes at this stage.
I have tried 2 different latest images of Angstrom with the same
effect.
with a Ubuntu prebuilt image from here
http://rcn-ee.net/deb/rootfs/oneiric/ubuntu-11.10-r6-minimal-armel.tar.xz
the board works fine
How to run WinSCP (Windows7 host) over USB to BeagleBone Ubuntu?
Another question is how to properly shut down / power down the
Beaglebone without the risk
corrupting files on SD card?
br
Jan