Networking Diagnostic Steps

I am trying to get the network running using the Angstrom Demo, kernel
2.6.27 build per wiki instructions. My first attempt was with wired
networking using the recommended powered 3-port GWC USB hub. However
no ethernet was detected.

Thinking that I might just have a defective ethernet port on the hub,
I bought the recommended Belkin USB Wireless G Adapter. But just as
with the wired networking attempt, there is no ethernet detection.

It seems there is basic device detection for the Belkin WiFi since
after boot, when I un-plug and re-plug the Belkin, the device gets
recognized with the following console messages:

usb 1-1.1: USB disconnect, address 3
usb 1-1.1: new high speed USB device using musb_hdrc and address 7
usb 1-1.1: configuration #1 chosen from 1 choice

In reading the postings, other people have setup networking using the
Angstrom Demo, so I assume that it must be some unique configuration I
have.

Can anyone suggest a series of diagnostic steps I can perform to
narrow down my problem?

Regards,
Bill

.

I am having the same problem...Does anybody have any info?

So this is interesting...below references are to images are found on

http://www.angstrom-distribution.org/demo/beagleboard/

This is wlan0 for belkin wirelessg Model FSD7050 in Angstrom. For me
at least these are the results so far..

With the uImage-2.6.26-r65-beagleboard.bin

         ---wlan0 does not show up, nor does it work ever
         +++Gui angstrom works great on HD monitor
         +++Mouse and keyboard show up and work great

With the uImage-2.6.27-r12-beagleboard.bin

         +++wlan0 shows up and works with the configuration from the
bottom of...
              http://code.google.com/p/beagleboard/wiki/HowToGetAngstromRunning
         ---Gui angstrom does not show up on the HD monitor
         +++Mouse and keyboard show up but are not responsive

With the uImage-2.6.28-r12-beagleboard.bin

        +++wlan0 shows up and works with the configuration from the
bottom of...
              http://code.google.com/p/beagleboard/wiki/HowToGetAngstromRunning
         ---Gui angstrom does not show up on the HD monitor
         +++Mouse and keyboard show up but are not responsive

-------In Summary one image that I have seen to work with the GUI does
not recognize the belkin wireless g, and the images that recognize the
belkin wirless g to not have GUI output to monitor. Has anybody else
had these results, or know how to get atleast one of these images to
do both?