to run a .bin file in beagle board using u boot

GoogleGroups
1

heyy,

we generated a .bin at 0x82000000 using ccs4 and loaded it using hyperterminal n trying to run it using uboot…
we tried using GO command by giving both the starting point address and cinit address separately…
both failed to work…wat do we hav to load along with the bin file???
or is there any mistake in giving the address???

Regards,
Thrishul

2

I am not an expert in this. But why can't you give a try using JTAG?

Thank you,
Johnson