UART as a MIDI port

Hello,
I need to setup the uart3 port of my beagleboard to work as a MIDI
port. A 31250bps baud rate is needed to accomplish that, but such baud
is not included in the baud rates list shown in the "OMAP35X Technical
Reference Manual" (chapter 17, Table 17-1).
Is there any way to set a custom baud rate for beagle's uarts?

Thank you in advance

Daniele

Yes, all the baud rates are achieved by dividing down the 48MHz functional clock by an integer divider. There is a figure somewhere in that chapter about all that.

Divider 118 when oversampling by 13 brings the rate to withing 0.13% or so. Should be adequate.

  • Juha