Unable to install I2CTools in on Beagle running Angstrom

Hello,

I am trying to install i2c-tools onto my beagleboard so that I can use
the DLP pico projector dev tools v2.

I downloaded the source code (i2c-tools-3.1.0.tar.bz2) for I2C-Tools
from http://www.lm-sensors.org/wiki/I2CTools

sudo tar -xjv -C /media/Angstrom/ -f i2c-tools-3.1.0.tar.bz2

I then put this SD card onto the Beagleboard and boot.

From the Beagle terminal, I ran

root@beagleboard:/media/mmcblk0p2/i2c-tools-3.1.0#make

but I got this error message:

-bash: make: command not found.

Can anyone make any suggestions on what went wrong here?

I am using Ansgtrom/3.0.8/

Here are the source of images I used to boot MMC
For 1st partition:
1. http://angstrom.s3.amazonaws.com/demo/beagleboard/MLO
2. http://angstrom.s3.amazonaws.com/demo/beagleboard/u-boot.bin
3. http://angstrom.s3.amazonaws.com/demo/beagleboard/uImage

For 2nd partition
1. http://angstrom.s3.amazonaws.com/demo/beagleboard/Angstrom-Beagleboard-demo-image-glibc-ipk-2011.1-beagleboard.rootfs.tar.bz2

Any suggestions are greatly appreciated.

opkg update ; opkg install i2c-tools