U-Boot SPL 2015.10-00001-g143c9ee (Nov 06 2015 - 15:27:19) bad magic U-Boot 2015.10-00001-g143c9ee (Nov 06 2015 - 15:27:19 -0600), Build: jenkins-github_Bootloader-Builder-274 Watchdog enabled I2C: ready DRAM: 512 MiB Reset Source: Power-on reset has occurred. MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 Using default environment Net: not set. Validating first E-fuse MAC cpsw Hit any key to stop autoboot: 0 gpio: pin 53 (gpio 53) value is 1 switch to partitions #0, OK mmc0 is current device gpio: pin 54 (gpio 54) value is 1 Checking for: /uEnv.txt ... Checking for: /boot.scr ... Checking for: /boot/boot.scr ... Checking for: /boot/uEnv.txt ... gpio: pin 55 (gpio 55) value is 1 1853 bytes read in 20 ms (89.8 KiB/s) Loaded environment from /boot/uEnv.txt Checking if uname_r is set in /boot/uEnv.txt... gpio: pin 56 (gpio 56) value is 1 Running uname_boot ... loading /boot/vmlinuz-3.8.13-bone79 ... 5644336 bytes read in 332 ms (16.2 MiB/s) loading /boot/dtbs/3.8.13-bone79/am335x-boneblack.dtb ... 26118 bytes read in 26 ms (980.5 KiB/s) loading /boot/initrd.img-3.8.13-bone79 ... 2878924 bytes read in 180 ms (15.3 MiB/s) debug: [console=ttyO0,115200n8 capemgr.enable_partno=BB-UART1,BB-UART4 root=UUID=6a2861e5-308d-4647-bf74-3be47204f308 ro rootfstype=ext4 rootwait coherent_pool=1M quiet init=/lib/systemd/systemd cape_universal=enable] ... debug: [bootz 0x82000000 0x88080000:2bedcc 0x88000000] ... Kernel image @ 0x82000000 [ 0x000000 - 0x562030 ] ## Flattened Device Tree blob at 88000000 Booting using the fdt blob at 0x88000000 Loading Ramdisk to 8fd41000, end 8ffffdcc ... OK Loading Device Tree to 8fd37000, end 8fd40605 ... OK Starting kernel ... Uncompressing Linux... done, booting the kernel. [ 0.383646] omap2_mbox_probe: platform not supported [ 0.539261] tps65217-bl tps65217-bl: no platform data provided [ 0.602342] bone-capemgr bone_capemgr.9: slot #0: No cape found [ 0.639450] bone-capemgr bone_capemgr.9: slot #1: No cape found [ 0.676558] bone-capemgr bone_capemgr.9: slot #2: No cape found [ 0.713667] bone-capemgr bone_capemgr.9: slot #3: No cape found [ 0.734259] bone-capemgr bone_capemgr.9: slot #6: BB-BONELT-HDMIN conflict P8.45 (#5:BB-BONELT-HDMI) [ 0.743884] bone-capemgr bone_capemgr.9: slot #6: Failed verification [ 0.750624] bone-capemgr bone_capemgr.9: loader: failed to load slot-6 BB-BONELT-HDMIN:00A0 (prio 2) [ 0.766099] omap_hsmmc mmc.5: of_parse_phandle_with_args of 'reset' failed [ 0.829186] pinctrl-single 44e10800.pinmux: pin 44e10854 already requested by 44e10800.pinmux; cannot claim for gpio-leds.8 [ 0.840852] pinctrl-single 44e10800.pinmux: pin-21 (gpio-leds.8) status -22 [ 0.848126] pinctrl-single 44e10800.pinmux: could not request pin 21 on device pinctrl-single Loading, please wait... Gave up waiting for root device. Common problems: - Boot args (cat /proc/cmdline) - Check rootdelay= (did the system wait long enough?) - Check root= (did the system wait for the right device?) - Missing modules (cat /proc/modules; ls /dev) ALERT! /dev/disk/by-uuid/6a2861e5-308d-4647-bf74-3be47204f308 does not exist. Dropping to a shell! modprobe: module i8042 not found in modules.dep modprobe: module ehci-hcd not found in modules.dep modprobe: module uhci-hcd not found in modules.dep modprobe: module ohci-hcd not found in modules.dep BusóBox v1.20.2 (Debian 1:1.20.0-7) built-in shell (ash) Enter 'help' for a list of built-in commands. /bin/sh: can't access tty; job control turned off (initramfs)