[ 176.341210] Restarting system. U-Boot SPL 2014.04-00014-g47880f5 (Apr 22 2014 - 13:23:54) reading args spl_load_image_fat_os: error reading image args, err - -1 reading u-boot.img reading u-boot.img U-Boot 2014.04-00014-g47880f5 (Apr 22 2014 - 13:23:54) I2C: ready DRAM: 512 MiB NAND: 0 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 *** Warning - readenv() failed, using default environment Net: not set. Validating first E-fuse MAC cpsw, usb_ether Hit any key to stop autoboot: 0 gpio: pin 53 (gpio 53) value is 1 Card did not respond to voltage select! mmc0(part 0) is current device Card did not respond to voltage select! gpio: pin 56 (gpio 56) value is 0 gpio: pin 55 (gpio 55) value is 0 gpio: pin 54 (gpio 54) value is 0 mmc1(part 0) is current device gpio: pin 54 (gpio 54) value is 1 SD/MMC found on device 1 reading uEnv.txt 1734 bytes read in 5 ms (337.9 KiB/s) gpio: pin 55 (gpio 55) value is 1 Loaded environment from uEnv.txt Importing environment from mmc ... Checking if uenvcmd is set ... gpio: pin 56 (gpio 56) value is 1 Running uenvcmd ... reading zImage 4103240 bytes read in 226 ms (17.3 MiB/s) reading initrd.img 2952608 bytes read in 165 ms (17.1 MiB/s) reading /dtbs/am335x-boneblack.dtb 25926 bytes read in 9 ms (2.7 MiB/s) Kernel image @ 0x82000000 [ 0x000000 - 0x3e9c48 ] ## Flattened Device Tree blob at 88000000 Booting using the fdt blob at 0x88000000 Using Device Tree in place at 88000000, end 88009545 Starting kernel ... Uncompressing Linux... done, booting the kernel. [ 0.378237] omap2_mbox_probe: platform not supported [ 0.532863] tps65217-bl tps65217-bl: no platform data provided [ 0.596721] bone-capemgr bone_capemgr.9: slot #0: No cape found [ 0.633829] bone-capemgr bone_capemgr.9: slot #1: No cape found [ 0.670938] bone-capemgr bone_capemgr.9: slot #2: No cape found [ 0.708047] bone-capemgr bone_capemgr.9: slot #3: No cape found [ 0.749535] omap_hsmmc mmc.5: of_parse_phandle_with_args of 'reset' failed [ 0.784820] pinctrl-single 44e10800.pinmux: pin 44e10854 already requested by 44e10800.pinmux; cannot claim for gpio-leds.8 [ 0.796524] pinctrl-single 44e10800.pinmux: pin-21 (gpio-leds.8) status -22 [ 0.803808] pinctrl-single 44e10800.pinmux: could not request pin 21 on devic e pinctrl-single Loading, please wait... Scanning for Btrfs filesystems systemd-fsck[289]: rootfs: clean, 58181/230144 files, 359918/919296 blocks [ 5.659576] c_can_platform 481cc000.d_can: invalid resource [ 5.709232] c_can_platform 481d0000.d_can: invalid resource [ 7.601032] libphy: PHY 4a101000.mdio:01 not found [ 7.606104] net eth0: phy 4a101000.mdio:01 not found on slave 1 Debian GNU/Linux 7 niihau ttyO0 default username:password is [debian:temppwd] Support/FAQ: http://elinux.org/Beagleboard:BeagleBoneBlack_Debian The IP Address for eth0 is: 192.168.1.99 The IP Address for usb0 is: 192.168.7.2 niihau login: