U-Boot SPL 2018.09-00002-g0b54a51eee (Sep 10 2018 - 19:41:39 -Trying to boot from MMC2 Loading Environment from EXT4... ** File not found /boot/uboot.env ** ** Unable to read "/boot U-Boot 2018.09-00002-g0b54a51eee (Sep 10 2018 - 19:41:39 -05ready DRAM: 512 MiB No match for driver 'omap_hsmmc' No match for driver 'omap_hsmmc' Some driC: 1 Loading Environment from EXT4... ** File not found /boot/uboot.env ** ** Unable to read "/boot/uboot.env" from mmc0:1 ** Board: BeagleBone Black not set. Validating first E-fuse MAC BeagleBone Black: BeagleBone: cape eeprom: i2c_probe: 0x54: BeagleBone: cape eeprom: i2c_probe: 0x55: BeagleBone: capboard_name=[A335BNLT] ... board_rev=[000C] ... switch to partitions #0, OK mmc0 is SD/MMC found on device 0 switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... gpio: pin 56 (gpio 56) value is 0 gpio: pin 55 (gpio 55) value Checking for: /uEnv.txt ... Checking for: /boot.scr ... Checking for: /boot/boot.scr ... Checking for: /boot/uEnv.txt ... gpio: pin 55 (gpio 55) value is 1 1712 bytes read in 16 ms (104.5 KiB/s) Loaded environment from /boot/uEnv.txt Checking if uname_r is set in /bootloading /boot/vmlinuz-5.10.168-ti-r71 ... 11342336 bytes read in 728 ms (14.9 MiB/s) debug: [enable_uboot ... uboot_overlays: Switching too: dtb=am335x-boneblack-uboot-univ.dtb ... fer=0x60000] ... uboot_overlays: loading /lib/firmware/BB-BONE-eMMC1-01-00A0.dtbo1614 bytes read in 65 ms (23.4 KiB/s) dtbo ... 5330 bytes read in 731 ms (6.8 KiB/s) uboot_overlays: loading /lib/firmware/BB-ADC-00A0.dtbo ... 654 bytes read in 456 ms (1000 Bytes/s) loading /boot/initrd.img-5.10.168-ti-r71 ... 7719588 bytes read in 497 ms (14.8 MiB/s) debug: [console=ttyS0,115200n8 bone_capemgr.uboot_ca at 88000000 Booting using the fdt blob at 0x88000000 Lo Loading Device Tree to 8f80b000, end 8f8a2fff ... OK Starting kernel ... Linux version 5.10.168-ti-r71 (voodoo@rpi4b4g-02) (gcc (Debian 00000] CPU: ARMv7 Processor [413fc082] revision 2 (ARMv7), cr=10VIPT aliasing instruction cache [ 0.000000] OF: fdt: Machine not found. [ 0.000000] cma: Reserved 48 MiB at 0x9c800000 000] Early memory node ranges [ 0.000000] node 0: [mem 0tup node 0 [mem 0x0000000080000000-0x000000009fdfffff] [ 0.000000] CPU: All CPU(s) started in SVC mode. [ mgr.uboot_capemgr_enabled=1 root=/dev/mmcblk0p1 ro rootfstype=exentry cache hash table entries: 65536 (order: 6, 262144 bytes, linear) [ 0.000000] Inode-cache hash table en000] Memory: 435700K/522240K available (15360K kernel code, 1446, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] rcu: 0.000000] rcu: RCU event tracing is enabled. [ 0.000000]es. [ 0.000000] rcu: Adjusting geometry for rcu_fanout_leaf=located irqs: 16 [ 0.000000] IRQ: Found an I000] TI gptimer clocksource: always-on /ocp/interconnect@44c0000[ 0.000032] clocksource: dmtimer: mask: 0xffffffff max_cyclesimer clockevent: 24000000 Hz at / ocp/interconnect@48000000/segme: colour dummy device 80x30 [ 0.002675] Calibrating delay lo initializing [ 0.049201] Yama: becoming mindful. [ 0.0424 (order: 0, 4096 bytes, linear) [ 0.049733] Mountpoint-cacs, linear) [ 0.051443] CPU: Testing write buffer coherency: [ 0.089750] EFI services will not be available. [ 0.10050activated (995.32 BogoMIPS). [ 0.100552] CPU: All CPU(s) started in SVC mode. [ 0.101488] devtmpfs: initrder: 2, 16384 bytes, linear) [ 0.149221] pinctrl core: initalid. [ 0.151359] NET: Registered protocol family 16 [ 0.154604] DMA: preallocated 256 KiB pool for atomrmal governor 'bang_bang' [ 0.197743] thermal_sys: Registere [ 0.198689] cpuidle: using governor ladder [ 0.198777] aq benchmark and using algorithm neonx8 [ 4.912934] raid6: usu: Default domain type: Translated [ 4.925415] SCSI subsyst0464] videodev: Linux video capture interface: v2.00 [ 4.930s_core: Software ver. 5.3.6 - Copyright 2005-2007 Rodolfo Giometti [ 4.930748] PTP clockocksource: Switched to clocksource dmtimer [ 5.996818] VFS: 997293] FS-Cache: Loaded [ 5.997699] CacheFiles: Loaded [ 0, 6144 bytes, linear) [ 6.014443] TCP established hash tablstablished 4096 bind 4096) [ 6.015301] MPTCP token hash tabl 6.029234] RPC: Registered named UNIX socket transport module. egistering the id_resolver key type4.1 backchannel transport mod: enabled with armv7_cortex_a8 PMU driver, 5 counters available [ 6.485717] Key type id_on 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. Hz 6.4879] xor: automatically using best checksumming function neon layer SCSI generic (bsg) driver version 0.4 loaded (major 243) [ 7.520465] ti-sysc: probe of 48040000.target-module failed with error -16 [ 7.740729] omap-mailbox 468 [ 8.441895] gpio-of-helper ocp:cape-universal: Failed to o-of-helper ocp:cape-universal: Failed to create gpio entry [ ] enabled [ 9.325743] 48022000.serial: ttyS1 at MMIO 0x48022l: ttyS3 at MMIO 0x481a6000 (irq = 43, base_baud = 3000000) is a00.serial: ttyS5 at MMIO 0x481aa000 (irq = 45, base_baud = 30000supply vcc not found, using dummy regulator gulator or ldn't get reset GPIO [ 9.729974] cpsw 4a100000.ethernet: ini759675] usbcore: registered new interface driver smsc95xx [ pply vcc not found, using dummy regulator [ 9.777071] am335xd' Host Controller (EHCI) Driver [ 9.823853] ehci-platform: i-omap: OMAP-EHCI Host Controller driver 9.855002] musb-hdrc musb-hdrc.1: new USB bus registered, assigusb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber 9.883437] usb usb1: Manufacturer: Linux 5.10.168-ti-r71 musb- h] hub 1-0:1.0: 1 port detected [ 9.918129] omap_rtc 44e3e000.rtc: registered as rtc0 [ 9boot=0 soft_margin=60 sec soft_panic=0 (nowayout=0) [ 9.9608 property 'ti,am3352' found operations [ 9.979504] sdhci: Seregulator [ 10.014771] ledtrig-cpu: registered to indicate acm 53100000.sham: will run requests pump with realtime priority er usbhid [ 10.073781] mmc1: SDHCI controller on 481d8000.mmc[ 10.159925] mmc1: new high speed MMC card at address 0001 [ 2.00 MiB [ 10.199601] mmcblk1boot1: mmc1:0001 MMC04G partiti 10.240537] Key type dns_resolver registered [ 10.244961] mpmulation handler [ 10.260637] omap_voltage_late_init: Voltageprovisioning registered [ 10.305485] Btrfs loaded, crc32c=crc [ 10.388183] tps65217-bl: Failed to locatwrbutton: DMA mask not set [ 10.404323] input: tps65217_pwr_b: 32768 byte 24c256 EEPROM, writable, 1 bytes/write [ 10.4372 GPIO id=0 name='P8_03' [ 10.458486] gpio-of-helper ocp:cape-ersal: Allocated GPIO id=4 name='P8_07' [ 10.489005] gpio-of-llocated GPIO id=6 name='P8_09' [ 10.504093] gpio-of-helper oape-universal: Allocated GPIO id=10 name='P8_13' [ 10.534525]IO id=11 name='P8_14' [ 10.542315] gpio-of-helper ocp:cape-unversal: Allocated GPIO id=15 name='P8_18' [ 10.572857] gpio-o: Allocated GPIO id=17 name='P8_20' [ 10.588103] gpio-of-helpr ocp:cape-universal: Allocated GPIO id=21 name='P8_24' [ 10.] gpio-of-helper ocp:cape-universal: Allocated GPIO id=24 name='ape-universal: Allocated GPIO id=26 name='P8_29' [ 10.656785] [ 10.679647] gpio-of-helper ocp:cape-universal: Allocated GPIersal: Allocated GPIO id=34 name='P8_37' [ 10 name='P8_38' [ 10.725414] gpio-of-helper ocp:cape-universal:Allocated GPIO id=39 name='P8_42' [ 10.755918] gpio-of-helperted GPIO id=41 name='P8_44' [ 10.771175] gpio-of-helper ocp:ced GPIO id=44 name='P9_11' [ 10.794077] gpio-of-helper ocp:caversal: Allocated GPIO id=47 name='P9_14' [ 10.816978] gpio-o-helper ocp:cape-universal: Allocated GPIO id=51 name='P9_18' [r ocp:cape-universal: Allocated GPIO id=53 name='P9_20' [ 10.85706] gpio-of-helper ocp:cape-universal: Allocated GPIO id=57 n gpio-of-helper ocp:cape-universal: Allocated GPIO id=59 name='Ppe-universal: Allocated GPIO id=61 name='P9_28' [ 10.924250] f-helper ocp:cape-universal: Allocated GPIO id=64 name='P9_31' 10.970066] gpio-of-helper ocp:cape-universal: Allocated GPIO [ 11.047702] davinci_mdio 4a101000.mdio: phy[0]: device 4a1010conds (-22) [ 11.076869] sdhci-omap 48060000.mmc: Got CD GPIO[ 11.119139] mmc0: SDHCI controller on 48060000.mmc [48060000.[ 11.201550] tda998x 0-0070: found TDA19988 [ 11.209960] tilcdc 4830e000.lcdc: boun Cannot find any crtc or sizes [ 11.243311] of_cfs_init: OK Starting version 247.3-7+deb11u4 e system ... Begin: Running /scripts/local-top ... done. Begin: Running /scripts/local-premount ... dBegin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. done. Begin: Running /scripts/local-block ... done. BBegin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... Begin: Running /scripts/local-block ... Begin: Running /scripts/local-block ... done. Begin: Running /scripts/local-block ... done. done. Gave up waiting for root file system device. Common problt-in shell (ash) Enter 'help' for a list of built-in commands. (initramfs)