Does anyone succeeded to actually use ArduCam V3Link Camera Kit (SKU B0491)
on the BeagleY-AI board?
I use BeagleY-AI Debian 12.9 2025-03-05 Minimal (v6.1.x-ti) image.
I followed BeagleY-AI manual,
paragraph 5.9 Using the Arducam Dual V3Link Camera Kit.
V3Link HAT is connected to the BeagleY-AI board (to the DSI/CSI connector) and is detected on I2C bus 3 via command i2cdetect -r -y 3.
The module is detected at address 0x0c, the camera is detected at address 0x10.
Camera is at RX1.
So far, so good, but how to actually use the camera?
BeatleY-AI manual stops at switching CSI channels,
Arducam Wiki also does not shed light on the matter.
A demo or example would be very helpful.