clone beaglebone rev.A6

GoogleGroups
1

Hi,
I entered the entire BeagleBone in a printed circuit board made ​​by me and now
I need to write the EEPROM U13 for the initialization of the FT2232.
How is it possible to do this?
Is there an instructions manual that shows how to read what is written on the
original EEPROM and then to write it on a new one?
Special tools, hardware and software, are required?

Regards

Mariano

2

Do a search on the Forums. This has been covered on numerous occasions and so you should be able to find the process for writing the EEPROM explained out.

Gerald