Could you please guide me on how to restore the system to a normal boot state?

BeagleV
1

I installed the Debian O/S image (beaglev-fire-debian-13-iot-v6.6-riscv64-2025-07-21-4gb.img) on my BeagleV-Fire. I created a user.spi output file on my PC to perform a simple LED ON/OFF task using the FPGA. On the Debian O/S, I successfully flashed the user.spi file (copied from my PC) using the change-gateware.sh command.

Afterward, I shut down the BeagleV-Fire and attempted a reboot. However, the boot process hangs at the following messages and does not proceed further:

"HSS: decompressing from eNVM to L2 Scratch ... Passed DDR training ... Passed ( 1544 ms)"

What is the problem here? Could you please guide me on how to restore the system to a normal boot state?"

How to run my FPGA code on BeagleV-Fire
2

Well, you haven’t given us much to go on, so I’ll just throw this out here:

I think it’s pretty safe to say that whatever you put in that Gateware is what bricked your board.

An Flashpro 6 is your only salvation at this point.