Dear all,
Just connected beagleboard. I could see its logo on monitor but i see nothing on my hyperterminal except one character(alphabet) randomly each time I connect.
I thought possible reasons could be
- improper settings in hyperterminal
- wrong connection of IDC10 cable on to RS232 slot of the board
so, i made a double check to make sure that I am doing right with above two points.
Any ideas on the problem?
to power up the board am just using mini B to std USB cable to usb hub which is powered up externally using an adapter.
Also I do not see the logo on monitor when all the peripherals are connected at once.
-aamer