Pin_Config change

Hi,

we are designing new board same like beaglebone black using OSD335x IC, we are planning to change the pin configurations, so we want to write new pinmux code in /opt/source/bb.org-overlays/tools/pinmux-generator/ Path.

But after writing dts for new board where to invoke that file

Please help me in this

Thanks

**DISCLAIMER:**This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you are not the named addressee, copying, dissemination, distributing or taking any action in reliance on the contents of this information is strictly prohibited. Please notify the sender immediately by email if you have received this email by mistake and delete this email from your system.

Any views or opinions presented in this email are solely those of the author and do not necessarily represent the organization. Employees of Utthunga Technologies Pvt. Ltd. are expressly instructed not to make defamatory statements and not to infringe or authorize any infringement of copyright or any other legal right by email communications. Any such communication is contrary to Utthunga’s policy and outside the scope of the employment of the individual concerned and Utthunga will not accept any liability in respect of such communication, and the employee responsible will be personally liable for any damages or other liability arising.

Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. Utthunga accepts no liability for any damage caused by any virus transmitted by this email.

You copy it to your main *.dtb..

It's just a generator, it's up to you to copy it to where it needs to go..

Regards,