RE: On All Channels and Flipping Out/Finding Out About Stepper Motors and Wiring from Kysan 1124090 - 7565/Using the Replicape for my BBB

GoogleGroups
21

Hello Again,

The Replicape people are diverting their attention to, yes to me being a tell-all, some other forms of software for 3D Printing right now. I think this is a fact but I could be wrong.

…

Outside of that idea, my motor got tapped and drilled but not in that order.

It did not work out. So, you all will no longer hear anymore about that Uncle Billie 3D Printing espionage crud. Otay.

Seth

P.S. I got a new motor, a stepper in fact, and it does its work on the BBB and the Replicape. Enjoy your life and the people around you. Thank you for the feedback. Signing off for now. See ya!

22

Hello,

I am done w/ my replicape for now. I have not been paying any attention to what the Replicape people have been doing w/ the source for the hardware and thus for now, I am clueless (as usual).

Seth