I can't seem to get the SD card that I got at the Beagle Board
workshop at ESC Boston to boot any more. I get a:
Texas Instruments X-Loader 1.4.2 (Feb 19 2009 -
12:01:24)
Reading boot
sector
Loading u-boot.bin from
nand
U-Boot 2009.01-dirty (Feb 19 2009 -
12:22:31)
I2C:
ready
OMAP3530-GP rev 2, CPU-OPP2
L3-165MHz
OMAP3 Beagle board + LPDDR/
NAND
DRAM: 256
MB
NAND: 256
MiB
MUSB: using high
speed
In:
serial
Out:
serial
Err:
serial
Board revision
C
Serial
#0282000300000000040323090e01f01b
Hit any key to stop autoboot:
0
Usage:
mmcinit - init mmc
card
Booting from
nand ...
NAND read: device 0 offset 0x280000, size
0x400000
4194304 bytes read:
OK
Wrong Image Format for bootm
command
ERROR: can't get kernel
image!
OMAP3 beagleboard.org #
I did build a new SD card following the instructions found in the wiki
and that card boots but I wanted to still be able to use the origonal
SD card and the demo programs that were on it. Is there a link to what
was on that card? I check the www.beagleboard.org/ESC page but did not
find it.
Thanks,
Joe